IEatHardDrives Posted October 9, 2005 Report Share Posted October 9, 2005 Ok my case came with two temp sensors one for the hard drive and cpu whats good to connect them I was think about just using duct tape on the top of the hard drive. Quote Link to post Share on other sites
Bubba Bob Posted October 9, 2005 Report Share Posted October 9, 2005 Thats what i did, only with electrical tape. Quote Link to post Share on other sites
Chappy Posted October 10, 2005 Report Share Posted October 10, 2005 Ok my case came with two temp sensors one for the hard drive and cpu whats good to connect them I was think about just using duct tape on the top of the hard drive.<{POST_SNAPBACK}>Using a dab of glue from a hot-melt gluegun works very well for this, just make sure to use a lower temp glue so as not to burn anything. Quote Link to post Share on other sites
Sir_Siddy Posted October 11, 2005 Report Share Posted October 11, 2005 Electrical tape is great but I had a bit of a problem when I used it and it was in my CPU fan wash. I think the hot air from my CPU might of screwed with the adhesive Quote Link to post Share on other sites
Bubba Bob Posted October 11, 2005 Report Share Posted October 11, 2005 What did you stick it to? Electrical tape isnt really ment for "surfaces", but mainly for sticking to itself.Also, was it cheap or brand name? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.