CsrLiz344 Posted April 29, 2011 Report Share Posted April 29, 2011 Apparently Windows did an update night before last, I have Windows 7 Home Premium, and now when I turn on my computer it will try to configure them. It sits there for about 10 minutes on 0%, then say it failed, and revert back, How can I take it out so it can try it again? Quote Link to post Share on other sites
Falcon1986 Posted April 29, 2011 Report Share Posted April 29, 2011 About two days ago I noticed a few new updates and decided to install them all. Unfortunately, I ran into a similar issue. On reboot, the updater reported that a problem was encountered and reverted to a pre-update state.I eventually got all the updates installed by doing the following. I went into WU and saw that only one of the important updates was selected by default. I allowed this single update to install and reboot the system. Afterward, applying the other updates was successful. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.