t'ni Posted November 24, 2006 Report Share Posted November 24, 2006 OK. I live way out on the edge of the bush. I am not connected to the power grid and I never will be. I am not going to run the generator all the time when I want to run a computer. (arg! 18 hours a day) I have cigarette lighters mounted in my house and a good enough supply of solar power to do the things I want.I've currently got a laptop, but I tend to be (err) a little hard on things and I'm afraid that I'm going to have to get another new computer and desktops are a lot cheaper for comparable products.So, I've this idea that since:1. plug computer into wall2. power supply converts AC to DC3. computer runs on DCyou must be able to make something to just run the whole darn thing on DC from the start.Does anyone have any ideas? Quote Link to post Share on other sites
bozodog Posted November 24, 2006 Report Share Posted November 24, 2006 (edited) Well, my friend. You sure have it made being off the grid. It's funny that we transmit power via AC, (most economical) but most electronics run on DC, as you already know. This link should help you. How Power Supplies WorkPower supplies, often referred to as "switching power supplies", use switcher technology to convert the AC input to lower DC voltages. The typical voltages supplied are: * 3.3 volts * 5 volts * 12 volts Edited November 24, 2006 by bozodog Quote Link to post Share on other sites
TheTerrorist_75 Posted November 24, 2006 Report Share Posted November 24, 2006 (edited) If your setup is 12VDC to the cigarette lighter get a 12VDC to 120VAC inverter. I have taken ones out of old ambulances that were being junked. Some of these put out enough wattage to run power tools. Edited November 24, 2006 by TheTerrorist_75 Quote Link to post Share on other sites
AdamF Posted November 24, 2006 Report Share Posted November 24, 2006 Uneconomical though. Best bet is to dig around the net for Car PC power supplies. These are specifically designed to run on 12v direct. No conversion from DC to AC to DC and quieter, too (no fan!) Quote Link to post Share on other sites
bozodog Posted November 25, 2006 Report Share Posted November 25, 2006 The problem I see is the different voltages used. If the PS does the AC/DC conversion AND the stepping down and separation of 3.3-5-12 volt applications, how do you apply that to the motherboard? Perhaps three different plugs connected to transformers of the required voltage, then wired into the proper leads on the motherboard? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.